Forensic Engineers and Consultants

Tag Archive: Code of Federal Regulations

  1. Event Data Recorders and Collision Investigation

    Leave a Comment

    Event Data Recorders (EDRs) were first introduced by General Motors (GM) in 1974.   That data was only available to GM; however, since 1994 more and more vehicle EDR’s have recorded data that can be gathered.  The data captured can be imaged and is being used by vehicle manufacturers, law enforcement officers, and collision reconstructionists to better understand what is happening in a collision.  In accident investigation, EDRs have the potential to provide independent measurements of crash data that would elsewise be estimated by (more…)

  2. Crawler Crane Calamity at Cement Plant

    Leave a Comment

    A production building was being constructed at a cement plant.  A large crawler crane was being used to install the pre-assembled metal wall framing of the building.  The weights and lift radii of the four wall framing sections, along with the rigging spreader and other lift equipment, were within the rated capacity of the crane. (more…)

  3. Crane Pile Driving: Who Owns This Loss?

    Leave a Comment

    The boom of a hydraulic crane was bent while removing temporary sheet piles at a construction site.  A vibratory hammer had been placed at the top of the sheet piles to both drive and remove the piles. The vibratory pile driving placed no significant loads on the crane boom, as that operation relied on the weight of the sheet piles and the vibration of the hammer to sink the piles into the soil.  The vibration of the hammer and the lifting force of the crane boom were needed to remove the sheet piles from the soil. (more…)

  4. Mobile Crane Ground Support

    Leave a Comment

    Mobile cranes depend on stability through their outriggers. These are the four “legs” that are deployed onto soil or other working surfaces adjacent to the crane.  When a mobile crane is set up at a site, the outriggers are deployed by a hydraulic mechanism that extends the four outriggers beyond the crane body and then jack the crane free of its wheels so that it is supported by the outriggers only. (more…)

  5. Crane Balancing Act

    Leave a Comment

    The operation of many cranes is a balancing act — one very similar to the childhood experience of using a playground seesaw. When the equipment isn’t properly balanced, the crane may succumb to the tipping force and fall to one side. Such a tipover is more common in mobile cranes rather than fixed-tower cranes.
    (more…)

Type ofLoss

Not sure what you're looking for?
Browse All

Select Loss Category
Select Sub-Category (choose category first)
View Now