Forensic Engineers and Consultants

Tag Archive: guard

  1. Conveyor Backstops: Sometimes One Isn’t Enough, Part 2

    Leave a Comment

    This is the second in a two-part blog series about conveying equipment that severely injured a worker at a mine. In case you missed it, click here to read Part 1 where I describe the incident and the mining equipment. In this part, I will discuss my engineering analysis of the incident and the machinery involved and share the conclusions I reached.

    The injured miner was a front-end loader operator. He was not a maintenance worker. He simply responded to a radio request for help with the conveyor. Power to the electric conveyor motors was locked out, but none of the maintenance workers did anything to lock out or block the hazardous gravitational potential energy in the heavy load of stone on the belt. (more…)

  2. Conveyor Backstops: Sometimes One Isn’t Enough, Part 1

    Leave a Comment

    This is the first of a two-part blog series describing an incident involving conveying machinery that seriously injured a miner. Part 1 describes the machinery and the incident. In Part 2 I will summarize my engineering analysis of the incident and share the conclusions I reached.

    A loaded, inclined conveyor belt may contain hazardous levels of energy due to gravity. To protect workers, anti-reverse devices called backstops are installed on inclined conveyors to prevent unexpected downhill movement. The Conveyor Equipment Manufacturer’s Association (CEMA) defines a backstop as: (more…)

  3. Machine Guarding and Risk Assessment

    Leave a Comment

    The Occupational Health and Safety Administration (OSHA) “Top 10 for 2018” violations once again have Machine Safeguarding earning a position on the list. Machine safeguarding was the 9th most cited standard as noted in the list below:

    1. Fall protection, construction (29 CFR 1926.501)
    2. Hazard communication standard, general industry (29 CFR 1910.1200)
    3. Scaffolding, general requirements, construction (29 CFR 1926.451)
    4. Respiratory protection, general industry (29 CFR 1910.134)
    5. Control of hazardous energy (lockout/tagout), general industry (29 CFR 1910.147)
    6. Ladders, construction (29 CFR 1926.1053)]
    7. Powered industrial trucks, general industry (29 CFR 1910.178)
    8. Fall Protection–Training Requirements (29 CFR 1926.503
    9. Machinery and Machine Guarding, general requirements (29 CFR 1910.212)
    10. Eye and Face Protection (29 CFR 1926.102)

    (Source: www.osha.gov/Top_Ten_Standards.html)

    (more…)

  4. Unguarded Shear Point on Force Tester Amputates Worker’s Finger

    Leave a Comment

    A worker was injured while testing gas springs similar to the type that hold the hatchback of an SUV open. The hazard that injured the worker was an unguarded shear point. The tester contained a mounting plate that was raised and lowered by a pneumatic cylinder.

    The pneumatic cylinder lowered the mounting plate while the worker’s fingers were in the hazardous, unguarded shear point. (more…)

Type ofLoss

Not sure what you're looking for?
Browse All

Select Loss Category