Forensic Engineers and Consultants

Tag Archive: Process Safety Management; Jennifer Morningstar

  1. Interpreting Industrial Incident Data – Lesson Learned

    Leave a Comment

    This is a case study about an incident I investigated involving a major upset in a distillation column.  This blog builds on the previous blogs about the Distributed Control System, DCS – Data is the Key.

    Distillation is a method of separating mixtures of compounds with differing boiling points.  Uncle Bill with his still on the hill separates ethanol, that boils at 173°F, from water that boils at 212°F.  If the mixture is heated to above 173°F, but below 212°F, the ethanol will boil, the vapor will travel up out of the unit and then can be condensed and served over ice with an olive…   Any mixture of two or more chemicals with different boiling points can be separated in this way.  The distillation (more…)

  2. What Does a Recovery Boiler Recover? – Quite a bit, actually!

    Leave a Comment

    The Kraft paper process was invented in 1879 and produces a stronger finished product that other paper manufacturing methods. One of the waste streams is known as black liquor and is a mixture of solids and water.  It contains lignin, hemicelluloses and chemicals used in the pulping process. The original process had no use for this harmful waste stream and it was dumped into nearby waterways, to their detriment!!!  Mr. G.H. Tomlinson invented the recovery boiler in the early 1930’s.  This development made the Kraft process the manufacturing method of choice, as explained below. (more…)

  3. OSHA’s Process Safety Management – Is This Process Covered?

    Leave a Comment

    In February of 1992, the OSHA Process Safety Management (PSM) standard was issued. The official title is: ‘Process Safety Management of Highly Hazardous Chemicals.’ As its title implies, not every facility is covered by this rigorous standard. A process must contain highly hazardous, as defined by OSHA, chemicals above a certain weight threshold, again defined by OSHA. Notice that this is a process by process determination, so there could be certain processes at a manufacturing facility that are not covered by this standard situated beside other processes that are.
    (more…)

Type ofLoss

Not sure what you're looking for?
Browse All

Select Loss Category