Forensic Engineers and Consultants

Tag Archive: machinery and equipment expert

  1. Conveyor Backstops: Sometimes One Isn’t Enough, Part 1

    Leave a Comment

    This is the first of a two-part blog series describing an incident involving conveying machinery that seriously injured a miner. Part 1 describes the machinery and the incident. In Part 2 I will summarize my engineering analysis of the incident and share the conclusions I reached.

    A loaded, inclined conveyor belt may contain hazardous levels of energy due to gravity. To protect workers, anti-reverse devices called backstops are installed on inclined conveyors to prevent unexpected downhill movement. The Conveyor Equipment Manufacturer’s Association (CEMA) defines a backstop as: (more…)

  2. Heavy Machinery Fires Caused by Hydraulic Hose Failures

    Leave a Comment

    Heavy machinery fires are often caused by hydraulic hose failures.  Pressurized hydraulic fluid escaping from a failed hose assembly can be atomized into a fine spray that can be ignited by heated engine surfaces such as the engine exhaust or turbocharger.

    Hydraulic hoses near the engine compartment of an excavator that burned.

     

    Hydraulic hoses often fail due to age and wear, requiring regular inspection and replacement of hydraulic hoses to prevent failures. Hoses may also fail if they are misrouted.  Misrouting can lead to the hose being pinched or causing it to chafe against a sharp metal surface. (more…)

  3. Unguarded Shear Point on Force Tester Amputates Worker’s Finger

    Leave a Comment

    A worker was injured while testing gas springs similar to the type that hold the hatchback of an SUV open. The hazard that injured the worker was an unguarded shear point. The tester contained a mounting plate that was raised and lowered by a pneumatic cylinder.

    The pneumatic cylinder lowered the mounting plate while the worker’s fingers were in the hazardous, unguarded shear point. (more…)

  4. Jury Claims Swamp Cooler is Not Defective; Interlocked Guards are Not Required

    Leave a Comment

    An evaporative cooler, also known as a “swamp cooler”, is an air conditioner that works by evaporating water.   A float valve keeps several inches of water in the bottom of the unit. A pump takes water from the pan to the top of a series of vertical pads made of absorbent materials like wood fibers. The water flows by gravity through the fiber pads. A fan pulls hot air from outside the house through the soaked pads. Water in the pads evaporates, cooling the air and increasing its humidity. The cooled and humidified air is blown back into the house. Evaporative coolers need to be cleaned periodically. (more…)

Type ofLoss

Not sure what you're looking for?
Browse All

Select Loss Category