Forensic Engineers and Consultants

Tag Archive: chemical release

  1. Interpreting Industrial Incident Data – Lesson Learned

    Leave a Comment

    This is a case study about an incident I investigated involving a major upset in a distillation column.  This blog builds on the previous blogs about the Distributed Control System, DCS – Data is the Key.

    Distillation is a method of separating mixtures of compounds with differing boiling points.  Uncle Bill with his still on the hill separates ethanol, that boils at 173°F, from water that boils at 212°F.  If the mixture is heated to above 173°F, but below 212°F, the ethanol will boil, the vapor will travel up out of the unit and then can be condensed and served over ice with an olive…   Any mixture of two or more chemicals with different boiling points can be separated in this way.  The distillation (more…)

  2. P&ID’s, If You Please – Piping and Instrumentation Diagrams Explained

    Leave a Comment

    When investigating an industrial incident, one piece of information I always ask for is the relevant P&ID’s for the process.  P&ID stands for Piping and Instrumentation Diagram and is defined as “A schematic diagram of the relationship between instruments, controllers, piping, and system equipment.” A set of P&ID’s for an entire facility allows you to trace the entire manufacturing process from raw material unloading to finished product loadout, including utilities like steam, water, fuel, and air. That’s great information to have, but isn’t especially useful (more…)

  3. The Paths of Chemical Exposure

    Leave a Comment

    The Safety Hierarchy states that hazards should be mitigated first by engineering controls, secondly by guarding, and lastly by warning/training.  When the first two, engineering controls and guards, fail in a manufacturing setting, a chemical release could occur. A forensic chemical engineer can help determine the root cause of that failure. (more…)

  4. Ammonia – The Good, The Bad, The Smelly… Part Two

    Leave a Comment

    Now that you know what ammonia is (see Part One here), how it behaves, and how to safely store it and work with it, let’s look at some areas in industry where it is used.

    Anhydrous ammonia has a use in pollution control.  Industrial boilers and power plants burn coal or natural gas to make steam and/or electricity. When the fuel is burned using air as the oxygen source nitrogen gets exposed to the heat as well because air is 79% nitrogen.  The nitrogen gets oxidized and forms several compounds referred to as NOx (NO, NO2, NO3).  NOx compounds are harmful to (more…)

  6. Chemical Engineers: More than Glorified Plumbers – Really!

    Leave a Comment

    As a senior at Virginia Tech, I was told that ChemE’s were little more than glorified plumbers.  Looking back, I’m pretty sure it was to keep our geek-egos in check. It was an effective tool! However, as I grew and traveled as a professional, it became an effective descriptor; applying to a larger scale and using a modifier or two for specific applications.  So, if you have a loss that falls into one of the categories below, a ChemE could be the expert you need. (more…)

Type ofLoss

Not sure what you're looking for?
Browse All

Select Loss Category
Select Sub-Category (choose category first)
View Now