Forensic Engineers and Consultants

Archive: Material Handling

WARREN WEBINAR: Property Claims Issues at Manufacturing Facilities

LIVE WEBINAR: “Property Claims Issues at Manufacturing Facilities” | Presented by WARREN’s President and Senior Consulting Engineer, Jennifer Morningstar, P.E., CFEI.

COURSE LEARNING OBJECTIVES
The learning objectives of this course are to provide the attendees with information on the four major facets of property claims that are commonplace in manufacturing facilities.

They are:

  1. Subrogation against third parties;
  2. Boiler & machinery vs property claims;
  3. Scope of loss, and
  4. Business interruption

Each facet will be explored and exemplified by at least one case study.

Read More

Author

The Paths of Chemical Exposure

The Safety Hierarchy states that hazards should be mitigated first by engineering controls, secondly by guarding, and lastly by warning/training.  When the first two, engineering controls and guards, fail in a manufacturing setting, a chemical release could occur. A forensic chemical engineer can help determine the root cause of that failure. Read More

Unguarded Shear Point on Force Tester Amputates Worker’s Finger

A worker was injured while testing gas springs similar to the type that hold the hatchback of an SUV open. The hazard that injured the worker was an unguarded shear point. The tester contained a mounting plate that was raised and lowered by a pneumatic cylinder.

The pneumatic cylinder lowered the mounting plate while the worker’s fingers were in the hazardous, unguarded shear point. Read More

Defective Vertical Baler Causes Serious Crush Injury to Operator’s Arm

I recently worked on an interesting case involving a box baler. An employee of a butcher shop put some empty cardboard boxes in a vertical box baler and pushed the control switch to compact the boxes. After the 30 by 60 inch platen weighing 851 pounds returned to its raised position, the employee reached into the open space above the bottom door on the baler and began to clear cardboard from the bale tie slots in the bottom of the raised platen. Suddenly, and without warning, the steel pin attaching the platen to the raised hydraulic cylinder rod failed. The heavy steel platen fell and crushed his arm which was outstretched over the baler door into the compaction space.

Read More

Type ofLoss

Not sure what you're looking for?
Browse All

Select Loss Category